Crow Runner Link Especificações descarregar pdf (Página 11)

CS-47 GSM Link - Configuration Guide Chapter 4 - Installing the Hardware Unit

CHAPTER 4.

Installing the Hardware Unit

IMPORTANT NOTES

If the GSM unit is being installed as a backup module, it should

NOT be installed too close to the panel.

It is recommended to configure the unit at the lab before

installing it at the customer’s premises.

 To install the hardware unit containing the CS-47 GSM link:

1. Chooseasuitablelocationwithinthesecuredareafortheunitwithin1to20

metersfromtheRunner.

2. Usingthepapertemplatedrill4holesinthewalltomounttheunit.

3. Usingfourscrewsandrawl‐plugs(wallplugs),fixtheunittothe

wallorany

otherfirmflatsurface.

4. PowerOFFtheRunneranddisconnectthebackupbattery.

5. ConnecttheunittotheRunnerbus.



Thebusconsistsoffourwires:Pos(+12V),Neg(‐12V),ClkandData.

SeePage6

6. IftheCS‐47linkis

goingtouseanexternal12VpowersupplytheGNDwire

fromthepowersupplyMUSTbeconnectedtotheGNDBus(Neg)terminal.

7. InserttheSIMcard intotheSIMcardholder.



Ifyouhaven’tcancelledcallwaitingandallroamingoptionsitisrecommended

todoso

bycontactingyourISP(InternetServiceProvider).

8. Ensurethattheantennaisproperlyconnected.

9. PowerONtheRunner.

10. Connectthebackupbattery.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Sem comentários

Crow Runner Link Especificações Página 11